Complete Guide to Temperature Control Vaping

Primarily kits and modes supporting the temperature control vaping are required. Moreover, the right coils also need to be selected as kanthal (normally used coil) does not support temperature control vaping. Normally stainless steel (SS), Titanium, Nickel etc can be used, which support the temperature control mode as their resistance change with a change in temperature. The characteristics of these coils will vary as to how they increase the resistance with a change in temperature.so Most mods and kits have this mode to adjust different coils for Temperature control. The mods or kit should have this setting to know exactly the TCR (Temperature coefficient of resistance) to send the output signal to adjust the temperature of the coil.

How to vape in Temperature Control (TC)

Simply, attach the tank with the device, select the temperature control from the interface. Different kits will have different interfaces or ways to select the temperature mode but you can adjust it while consulting their user manual. Select the wire type that you are using, if you have the option of giving the exact TCR ratio you can put that down as well. Check that the wattage output level is within the range of coil maximum and minimum level.

Install the coil and leave the device to let it adjust to normal room temperature. Make sure the mod and tank are firmly connected to avoid any inconvenience. Select the temperature level according to the maximum limit of coil and wattage level of the device. Make sure the resistance is accurate and lock the resistance if it is applicable to your device's features. Best Temperature

It is most often asked what the best temperature range is. Normally it is advisable to start from low temperatures before you go for higher temperatures. Commonly 390°F to 480° F (200°C to 250°C) is adopted. This figure can vary and you can adjust your own range as well.

You can vape quite comfortably at your specified temperature if it is in the required range of the device and coil. Adjustment can be done in temperature based on your personal taste and choice. The e-liquid quantity or power level of the device would also require you to change the temperature settings. If your e-liquid quantity is down then you need to lower the temperature.

Highs and Lows of Temperature Control

Highs

1. It prevents your coils from overheating, so it will not give that burning taste. Moreover, it will cut the output to avoid any excessive burning of the coil if its temperature reaches a certain limit. This increases the coil life quite drastically and increases the overall life of the device as a whole too.
2. The more life span means it is quite cost-effective and comparing the overall cost of vaping, this mode saves you a lot of money
3. The Vaping style can be adjusted as well. Lower temperature adjustment will give cool and long inhale while the higher temperature will give intense flavour and shorter inhale. As the E-liquid produce different notes at a different temperature, you can enjoy different versions from the same e juice using different temperature ranges.
4. As it uses only that power which will keep the coil at the desired temperature so it does not use excessive power, so give a long battery life
5. You can enjoy the consistent taste and vapours at the same temperature because the coil burns the same at every inhale.

Lows

1. It gets a bit complicated to use and is not advisable for beginners. It is a bit difficult to adjust to temperature mode. On the contrary, the wattage mode is quite simple and easy to use.
2. Every mod cannot be used as a temperature control device. Even if they have the option it will not work quite efficiently as it is normally designed to keep in view the other perspective of the design.
3. The specific coils for temperature mod are sometimes hard to find. Most tanks do not have TC compatible coil options so it becomes hard to remain on temperature mode.